Enter the voltage across a resistor and its resistance, and this calculator returns the current in amperes. It answers questions such as how many amps a heater draws or whether a circuit will stay under a fuse rating.
How to use the Current calculator
- Enter Voltage in volts. For an outlet load, use the supply voltage printed on the device.
- Enter Resistance in ohms. It must be greater than zero.
- Read current in amperes. Multiply by 1,000 to express it in milliamps.
How the current calculation works
How the current is calculated
The calculator divides voltage by resistance: I = V ÷ R. Both inputs must be non-negative, and resistance must be strictly positive. Very small resistances produce very large currents; 5 V across 0.0000001 ohm gives 50,000,000 A, which shows why a short circuit is dangerous rather than a realistic operating point.
If you know voltage and power instead of resistance, divide power by voltage to get current, or use the Ohm's Law Calculator after finding resistance from R = V² ÷ P.
Where real circuits differ
The formula assumes an ohmic load whose resistance stays put. Motor windings, LEDs and switch-mode power supplies draw current that is not proportional to voltage, so a resistance reading taken with a meter will not predict their running current.
Wire and connection resistance also add to the circuit. For long cable runs, include the cable's resistance in the total or the calculated current will be slightly high.
Worked example
Voltage: 120 V · Resistance: 14.4 ohm
- A 1,000 W element rated for 120 V has R = V² ÷ P = 14,400 ÷ 1,000 = 14.4 ohm.
- I = V ÷ R = 120 ÷ 14.4
- I = 8.333333 A
Result: 8.333333 A
Assumptions and limits
SI units; idealized classical equation. Not a safety assessment or certified engineering design. DC/resistive magnitudes.
Formula and worked examples last checked November 20, 2026. Spotted a problem? Report an error.
Frequently asked questions
How do I find amps from watts and volts?
Divide watts by volts. A 1,500 W appliance on 120 V draws 12.5 A. This works for resistive loads; for motors, the nameplate current is a better guide.
How many milliamps is 0.019 A?
Multiply amperes by 1,000: 0.019 A is 19 mA. Small electronics specifications are usually given in milliamps, so convert before comparing.
Why does lower resistance mean more current?
Current equals voltage divided by resistance, so with voltage fixed, halving the resistance doubles the current. Putting resistors in parallel lowers the total resistance and raises the current drawn from the source.
Does this work with AC voltage?
For purely resistive loads, yes, using RMS voltage. For reactive loads you need impedance, which includes a phase angle that this calculator does not handle.