Multiply current by resistance and you get the voltage across a resistor. This page does that one step: enter amperes and ohms, and it returns volts. Use it to find the voltage drop across a resistor, a sensor shunt or a length of cable.
How to use the Voltage calculator
- Enter Current in amperes. 150 mA is 0.15 A.
- Enter Resistance in ohms. Zero is allowed and gives 0 V.
- Read the voltage across that resistance in volts.
How the voltage calculation works
Voltage drop in practice
V = I × R tells you how much of the supply is used up across one part. In a series circuit the drops add up to the supply voltage, so you can check a design by summing them.
Cable runs are a common use. If a cable pair has 0.2 ohm of total resistance and carries 10 A, the drop is 2 V, and the load sees that much less than the source provides. A current shunt works the same way: a 0.01 ohm shunt carrying 5 A develops 0.05 V, which a meter reads to infer the current.
Input rules and limits
Current and resistance must be zero or positive. The answer is a DC or resistive magnitude; it does not include AC phase shifts. If you need to solve for current or resistance instead, the Ohm's Law Calculator has all three forms behind one menu.
Remember that resistance on a datasheet has a tolerance, so the true voltage drop can differ from the nominal figure by the same percentage.
Worked example
Current: 0.5 A · Resistance: 24 ohm
- V = I × R
- V = 0.5 × 24
- V = 12 V
Result: 12 V
Assumptions and limits
SI units; idealized classical equation. Not a safety assessment or certified engineering design. DC/resistive magnitudes.
Formula and worked examples last checked November 20, 2026. Spotted a problem? Report an error.
Frequently asked questions
How do I calculate voltage drop across a resistor?
Multiply the current through it by its resistance. A 330 ohm resistor carrying 10 mA drops 0.01 × 330 = 3.3 V.
Why does my device get less voltage than the supply?
Wires, connectors and switches all have some resistance, and each drops I × R. At high current even a fraction of an ohm can take away a volt or more, which is why long runs use thicker cable.
What is the voltage if the resistance is zero?
The calculator returns 0 V. An ideal conductor has no voltage across it, which is why a short circuit pulls the supply voltage down and draws heavy current.
Do voltages add in series?
Yes. In a series loop the individual drops add up to the source voltage, a rule known as Kirchhoff's voltage law. Run this calculator for each resistor and sum the results to check.