1. Home
  2. Science & engineering
  3. Electrical Power Calculator
Science & engineering

Electrical Power Calculator

Calculate DC electrical power from voltage and current.

Your numbers

V
A

Results update as you type. Nothing you enter is sent anywhere.

Result

24 W

P = V × I. SI units; idealized classical equation. Not a safety assessment or certified engineering design. DC or purely resistive unity-power-factor case; no AC phase angle modeled.

Formula used

P = V × I

Electrical power is voltage multiplied by current. Enter volts and amperes, and the calculator returns watts for a DC circuit or a purely resistive AC load. Use it to size a power supply, check a fuse or estimate heat in a component.

How to use the Electrical Power calculator

  1. Enter Voltage in volts, the potential difference across the load.
  2. Enter Current in amperes flowing through it.
  3. Read power in watts. Divide by 1,000 for kilowatts.

How the electrical power calculation works

FormulaP = V × I

P = V × I and its relatives

The calculator multiplies the two inputs, both of which must be zero or positive. If you know resistance instead of one of them, substitute from Ohm's law: P = I² × R or P = V² ÷ R. A 10 ohm resistor carrying 2 A dissipates 4 × 10 = 40 W.

For AC equipment with motors or electronic supplies, voltage × current gives apparent power in volt-amperes, which is higher than the real power in watts. The calculator assumes a power factor of 1 and does not model that difference.

From watts to energy and cost

Watts describe a rate. Multiply by hours to get watt-hours, then divide by 1,000 for kilowatt-hours, the unit on a utility bill. The Electricity Cost Calculator does that multiplication with your rate.

For a battery, divide its watt-hour capacity by the load in watts to estimate run time, keeping in mind that conversion losses will shorten it.

Worked example

Power of a space heater drawing 12.5 A at 120 V

Voltage: 120 V · Current: 12.5 A

  1. P = V × I
  2. P = 120 × 12.5
  3. P = 1,500 W, or 1.5 kW

Result: 1,500 W

Assumptions and limits

SI units; idealized classical equation. Not a safety assessment or certified engineering design. DC or purely resistive unity-power-factor case; no AC phase angle modeled.

Formula and worked examples last checked November 20, 2026. Spotted a problem? Report an error.

Frequently asked questions

How many watts is 12 V at 5 A?

Multiply them: 12 × 5 = 60 W. That is a typical figure for a small DC power supply, and it gives you the minimum rating you would want.

What is the difference between watts and volt-amperes?

Watts measure real power that does work or makes heat. Volt-amperes are voltage times current regardless of phase. They match only for resistive loads; for motors and many electronics, VA is larger.

How much power does a resistor dissipate?

Multiply the voltage across it by the current through it, or use I² × R. A 100 ohm resistor carrying 50 mA dissipates 0.0025 × 100 = 0.25 W, so a quarter-watt part would run at its limit.

How do I convert watts to kilowatt-hours?

Multiply watts by hours of use and divide by 1,000. A 1,500 W heater running for 3 hours uses 4.5 kWh.

Sources