1. Home
  2. Science & engineering
  3. Resistance Calculator
Science & engineering

Resistance Calculator

Find resistance from voltage and current.

Your numbers

V
A

Results update as you type. Nothing you enter is sent anywhere.

Result

5 ohm

R = V/I. SI units; idealized classical equation. Not a safety assessment or certified engineering design. DC/resistive magnitudes.

Formula used

R = V/I

If you can measure the voltage across a component and the current through it, this calculator gives its resistance in ohms. It is the quickest way to check a heating element, identify an unmarked resistor in a working circuit, or confirm a load matches its rating.

How to use the Resistance calculator

  1. Enter Voltage, the potential difference across the component, in volts.
  2. Enter Current, the amperes flowing through it. It must be above zero.
  3. Read resistance in ohms. Divide by 1,000 for kilohms.

How the resistance calculation works

FormulaR = V/I

R = V ÷ I and its limits

The calculation divides voltage by current. A current of zero is rejected, because an open circuit has no finite resistance to report. Negative values are rejected too, so enter magnitudes.

The result is the ratio at that operating point. For a resistor or heater wire, the ratio stays close to constant. For an LED or diode, the ratio you calculate applies only at the voltage you measured and changes sharply at other voltages.

Measuring well

Measure voltage directly across the component, not across the whole supply, if anything else is in the circuit. Measure current in series with it. Taking both readings at the same moment matters for parts that heat up, because their resistance can drift as they warm.

If you only have a power rating, resistance for a resistive load is V² ÷ P. A 60 W load rated for 12 V works out to 144 ÷ 60 = 2.4 ohm. Use the Ohm's Law Calculator to run the other two rearrangements.

Worked example

Resistance of a 12 V lamp drawing 0.25 A

Voltage: 12 V · Current: 0.25 A

  1. R = V ÷ I
  2. R = 12 ÷ 0.25
  3. R = 48 ohm while the lamp is lit

Result: 48 ohm

Assumptions and limits

SI units; idealized classical equation. Not a safety assessment or certified engineering design. DC/resistive magnitudes.

Formula and worked examples last checked November 20, 2026. Spotted a problem? Report an error.

Frequently asked questions

What resistor do I need to drop a voltage?

Divide the voltage you want to drop by the current that will flow. Dropping 3 V at 20 mA needs 3 ÷ 0.02 = 150 ohm. Check the power the resistor dissipates as well, V × I, which is 0.06 W in that case.

Why is cold resistance different from what I calculate?

The calculator uses the voltage and current at the moment you measured them. Many conductors change resistance with temperature, so a lamp filament or heater measured cold with an ohmmeter can read noticeably lower than the running value.

How do I convert ohms to kilohms?

Divide by 1,000. 4,700 ohm is 4.7 kΩ, and 1,000,000 ohm is 1 MΩ. Enter the value in plain ohms in this calculator.

Can resistance be negative?

Not for ordinary passive components; the calculator rejects negative inputs. Some devices show negative differential resistance over part of their range, but that is a different measurement from this simple ratio.

Sources