The Roofing Calculator converts a roof's footprint into its actual sloped surface area using the pitch. That surface area, not the footprint, is what shingles, underlayment and roofing quotes are based on.
How to use the Roofing Calculator (Roof Area) calculator
- Enter Horizontal roof footprint in square meters, including the overhangs, measured as the plan area seen from above.
- Enter the pitch as Pitch rise and Pitch run in the same units, such as 6 and 12 for a 6-in-12 roof.
- Set a Waste allowance for starter rows, ridge caps, cuts and overlaps, then read the roof area in m².
How the roofing calculator (roof area) calculation works
How the pitch factor works
A sloped roof is longer than its shadow on the ground. The calculator multiplies the footprint by √(1 + (rise ÷ run)²), the length of the slope for each unit of horizontal run. For a 4-in-12 roof the factor is 1.054; for 6-in-12 it is 1.118; for 8-in-12 it is 1.202; and for 12-in-12 it is 1.414.
This works for any roof where every plane has the same pitch, including simple gables and hips, because each plane scales the same way. Roofs with sections at different pitches should be calculated one section at a time.
Converting to roofing squares
US roofers price and order in squares: one square is 100 square feet of roof area. Multiply the calculator's m² result by 10.764 for square feet, then divide by 100.
Ridge caps, hips and valleys add material beyond the surface area, and complex roofs with dormers waste more on cuts. A roofer's measurement or an aerial report is worth getting for anything beyond a simple gable.
Worked example
Horizontal roof footprint: 150 m² · Pitch rise: 6 units · Pitch run: 12 units · Waste allowance: 10 %
- Slope ratio: 6 ÷ 12 = 0.5.
- Pitch factor: √(1 + 0.5²) = √1.25 ≈ 1.118034.
- Sloped area: 150 × 1.118034 ≈ 167.705 m². With 10% waste: × 1.10 ≈ 184.4756 m².
- In squares: 184.4756 × 10.764 ≈ 1,985.7 ft², or about 19.9 squares.
Result: 184.475608 m²
Assumptions and limits
Uniform planar pitch only; footprint must include overhangs. Rise/run use matching units. No hips, valleys or complex geometry.
Formula and worked examples last checked November 20, 2026. Spotted a problem? Report an error.
Frequently asked questions
How do I find my roof pitch?
Measure how many inches the roof rises over 12 inches of horizontal run, often with a level and tape in the attic or at a gable end. A rise of 6 inches over 12 is a 6-in-12 pitch. Enter 6 as rise and 12 as run.
How many squares is my roof?
Convert the sloped area to square feet and divide by 100. A 184.5 m² roof is about 1,986 ft², or roughly 19.9 squares; order to the next whole or half square your supplier sells.
Why is my roof area bigger than my house's floor area?
Two reasons: the overhangs extend past the walls, and the slope makes the surface longer than the footprint. A 6-in-12 roof has about 11.8% more surface than its plan area.
Does this work for a flat roof?
Yes. Enter a rise of 0 and any run, such as 12. The pitch factor becomes 1, so the roof area equals the footprint plus waste.